Do you need a special blade to cut melamine?

To cut melamine or laminate boards without chipping, your saw must be equipped with a double-sided laminate / melamine blade. These blades are specially designed for cutting and at the same time minimize chipping. Before making your cuts, get your table sawed as best you can.

How do you cut laminate shelves without chipping?

cut laminate properly for smooth edge A common problem with cutting laminate is a rough, chipped edge, which is usually caused by a dull saw blade or the use of a saber saw. Using a sharp, carbide-tipped blade (preferably on a table saw) is the best bet for a smooth edge.

How do you cut a melamine with a skill saw?

First, designate your cutline, and score both sides lightly with a utility knife. Second, set your table saw or circular saw blade to cut about 1/4″ into one surface of the melamine. Here, you’re not really cutting the piece to length as much as you are creating a clean edge in one face.

How do you cut laminate shelves with a circular saw?

How to Cut Laminate Shelving with a Circular Saw

1. Step 1: Measure & Score. Measure and draw out your cut line, and then score the laminate on both sides of the cut line using a utility knife.
2. Step 2: Adjust Your Circular Saw & Make a Scoring Cut.
3. Step 3: Make the Final Cut.

What circular saw blade is best for melamine?

The recommended blade for cutting the finished board products is the Bosch 10″ 80 tooth carbide blade or with a hand-held circular saw, a 100 tooth 5-1/2″ blade (iffy as results will show, but may be good enough).

How do you cut Formica without chipping?

You can minimize the potential for chipping if you use a finish blade with lots of teeth, making sure the sharp is keen. You can further reduce the chance of chipping by using masking tape along the cut line and cutting through the tape. As with all cutting, measure at least twice and mark the line well and clearly.