What happens if my coolant temperature sensor goes bad?

If the coolant temperature sensor goes bad it can send a false signal to the computer and throw off the fuel and timing calculations. It is not uncommon for the coolant temperature sensor to fail and send a permanently cold signal to the computer. This will reduce fuel economy, and may hinder engine performance.

Can a bad coolant temperature sensor cause car not to start?

The sensor will not cause a no start. It could cause a hard start and a rich or lean condition only.

How much does it cost to replace coolant sensor?

The average price for an engine temperature sensor replacement is between $150 and $193. Labor costs are between $82 and $105 while parts are between $66 and $88. Taxes and fees aren’t included in the estimate.

What sensor causes a car not to start?

A bad Crankshaft Position sensor is a common cause of no starts. The signal from this sensor goes to the PCM or ignition module that switches the ignition coil(s) on and off. If you have an RPM signal, a bad ignition module or PCM may not be switching the coil(s) on and off.

How long does a coolant temperature sensor last?

about 100,000 miles
Often, the engine coolant temperature sensor must be replaced at about 100,000 miles. If you don’t properly maintain the engine cooling system, the sensor could fail much earlier.

Can you drive with a bad crankshaft sensor?

Once the position sensor becomes compromised or if you have symptoms of a problematic crankshaft that you can’t ignore, do not drive your vehicle. If the problems are more severe, driving can cause substantial engine damage that could cost you a lot more to repair.

Why does my car keep turning over but not starting?

If the car cranks when you turn the key, but the engine won’t start, it could be because fuel isn’t getting to the engine. One potential reason for this could be dirty fuel injectors. Over time, the fuel injector nozzles can become clogged with rust, corrosion or debris.

Do you need to drain coolant to change coolant temperature sensor?

Open the radiator valve and drain about two to three quarts of coolant. You only need to remove enough to drop the level below the sensor. Then close the drain valve. This will minimize coolant waste when you remove the sensor.

https://www.youtube.com/watch?v=_JXHgWumzvw