Is it hard to drill a well?

Drilling a shallow well is a pretty simple task, going down about 25 feet or so when you hit first water (at least in my location). This type of well could be drilled in a weekend by hand using a general purpose, extendable post-hole auger. Shallow wells have a difficult time keeping up with average water usage.

How long does it take to drill for a well?

1-2 days
How long does it take to complete a well system? Depending on drilling conditions, drilling a well typically takes 1-2 days. Pump system installation takes about a day, and can be done at any time after the well is drilled.

What is considered a deep well?

These wells tap into a water table deep underground, as far down as 1000 feet. Deep wells have higher protections against potential surface contaminants. There are some drawbacks to deep water wells.

How deep do you have to dig to hit water?

You will need to dig at least 30 feet below the surface to find high-quality water. But you’ll need to dig even deeper to find better water that will be the safest for your family to drink.

How deep should you drill a water well?

On average, to be deep enough to reach the bedrock, a water well would need to be anywhere from 100 to 500 feet deep, though there are some places where the well needs to be up to 1000 feet deep.

How much does it cost to drill a 100 foot well?

Well Drilling Cost

How deep is too deep for a well?

In order to allow for maximum ground filtration to remove impurities, your well depth should be at least 100 feet. As a general rule, the deeper you drill, it’s more likely that there will be minerals present.

Why water from deep well is clean?

Water quality in a deep well usually changes more slowly than in a shallow well. That’s because groundwater does some mixing as it moves through the aquifer. A spill a mile away from your deep well in the Basin and Range aquifer might be substantially diluted with clean aquifer water before it gets to your well.