Why does my radio keep going into demo mode?

It probably means you have the radio wired wrong. Radios like that have two power connections, one for turning the radio on and off with the ignition power and the other for retaining settings such as preset stations, audio tone and balance settings, and the last station played and volume.

How do I reset my Kenwood radio?

Kenwood Car Stereo is the best in the market of stereos….Kenwood Factory Reset

1. Step 1: Hold Eject CD And Volume button. On the left of the CD slot, you will find the Eject CD button.
2. Step 2: Press The Reset Button.
3. Step 3: Tap the “Initialize All” button.
4. Step 4: Again, press the reset button.

How do I get my dual radio out of demo mode?

If DEMO continues to appear after verifying that the connection is correct, make sure that the DEMO setting is disabled.

1. Press MENU.
2. Rotate the control dial to select DISPLAY.
3. Press the control dial.
4. Rotate the control dial to select DEMO.
5. Press the control dial.
6. Rotate the control dial to select DEMO OFF.

How do I fix my Kenwood radio when it wont turn on?

If the radio will not turn on, first check the fuse located on the back of the radio. If the fuse is burnt, replace with a fuse of the same amperage rating. The guide to replacing the fuse can be found here.

Why doesn’t my radio turn off when I turn my car off?

Usually, a car radio would stay on if you have wiring problems like faulty memory wire or incorrect switch wiring. Moreover, a faulty ignition switch or ignition cylinder issue can also be the reason why your car radio fails to shut off every time with ignition off.

How do you fix a Kenwood protect mode?

Turn off the receiver and let it cool for a few hours; then try again. If the protection mode warning doesn’t go away on its own, press the reset button. If that doesn’t work, disconnect the power lead from your receiver for 30 seconds and then reconnect it. If it still doesn’t work, it’s time to take it to the dealer.

Why is my Kenwood radio in protect mode?

Kenwood equips its receivers with a protection mode to safeguard them. Your stereo receiver is going into protection mode because the receiver has an internal short, a speaker is bad or the speaker wiring has a problem, such as incorrect wire gauge or bad connections.