How do you fix an airlock in a water dispenser?

Airlock – This is a very simple problem that occasionally occurs with coolers that have just been installed or serviced. The cooler simply needs to be reset. This can be done by holding down/pressing both taps at the same time for a couple of minutes to allow the air to escape.

How do you troubleshoot a water dispenser?

How to Troubleshoot a Faulty Refrigerator Water Dispenser

1. Straighten or Replace the Dispenser Tube.
2. Clean Out the Water Lines.
3. Inspect and/or Change the Water Filter.
4. Test the Water Pressure.
5. Defrost the Water Line.
6. Check the Pressure Switch.
7. Inspect for a Faulty Door Switch.
8. Replace the Control Board.

How do I reset my water dispenser?

To do a reset, drain a few cups of water out of both the hot and cold sides of the water cooler. Then turn the switches in the back of the cooler off. Unplug your water cooler, and leave it unplugged for 24 hours. When you do turn it back on, be sure to turn the back switches on as well.

How does a bottle dispenser work?

Most water dispenser work by having a 5-gallon water bottle upside down on the top of the machine. This allows gravity and vacuum pressure to do the job of filling a glass when someone presses water spigot. When this happens, air is allowed into the bottle so water can escape into your glass or bottle.

How do I fix my Primo water dispenser not working?

Turn all switches to the off position. Unplug the unit. After a few minutes, plug the unit back in, turn the switches back on and give it one hour and recheck the water temperature. If this does not correct the issue, please call our Customer Service Center.

How do you prime a water cooler?

Steps to Verify Issue:

1. Place a water glass under the dispenser.
2. Press and hold the Water button for no more than 60 seconds. Some air may dispense before water begins to flow.
3. If there still is no water, wait 10 seconds, then press the Water button again. Once the water tank is full, the unit begins dispensing.

Why is the water dispenser leaking?

It is normal for the water dispenser to leak a few drops (less than 1cc) of water after being used. You may also notice water dripping after dispensing crushed ice. If the dispenser has a steady drip, it may be caused by air in the water line or an improper water line connector installation after door removal.

Why does my hot water dispenser sputter?

If the water temperature in your tank is set too high, it may boil and cause spitting/sputtering from the faucet. Depress or twist the dispenser handle for 20 seconds to allow cold water to enter the tank. Allow the water to reheat to the new setting.

Why is water not coming out of my water cooler?

If no water is flowing from your bottled water cooler or dispenser, there are generally two main causes: either the reservoir has become frozen, or the air filter is water-saturated due to a leaky bottle or dirty. Replace the bottle and plug the cooler back into the electrical source.

How long do water dispensers last?

The main advantage of a point of use water dispenser is that they never need to be refilled. Once the unit has been set up, the flow of water is continuous. They only things that need to be changed are the filters, which normally last 6-12 months.