How can I improve my decoder signal?

You can fix DStv signal strength by checking the following:

1. F-type connectors.
2. LNB alignment.
3. Satellite dish alignment.
4. LNB quality.
5. Satellite dish position.
6. Check for obstacles in the way of your satellite dish.

How do I align my DStv LNB?

Step two – Align the DSTC dish correctly

1. Make use of a sat meter to point the dish in the correct direction.
2. Correct the elevation, which is adjustable on the side. You will see degree markers.
3. By having a look at the dish, adjust the LNB to point at 4 O’clock. Keep testing it for optimal signal quality.

How do I position my DStv dish?

It needs to be on 53 degrees below the horizontal clockwise on the right hand side looking at the dish. Better to judge it as being around the half past 4 position on a clock face. Step 3: This gets harder make sure the Dstv dish is facing roughly east, the direct the sun comes up in the morning.

Why is my DStv signal quality low?

What to Do When Your DStv Decoder Loses Signal. If you are experiencing bad signal quality, it could be due to a faulty angle adjustment of the LNB. Bad weather will especially influence your signal reception. The low-noise block downconverter (LNB) is the receiving device that is fitted on your satellite dish.

How do you fix a DStv when it says no signal?

Fix a DStv no signal error by following the steps below:

1. Step 1: Check your DStv connection cables. This is one of the easiest checks you can do on your own.
2. Step 2: Reboot your decoder.
3. Step 3: Inspect your DStv satellite dish.
4. Step 4: Check your LNB.
5. Step 5: Call the approved DStv installer.

How do you set a LNB position?

How to Adjust the LNB on a Satellite Dish

1. Enter your satellite box’s setup menu.
2. Check transponders 1 and 2.
3. Loosen the bolts that hold your dish in place.
4. Move the dish experimentally from side to side and up and down; no more than 1/2 inch at a time.
5. Secure the bolts to the dish back in place as tightly as possible.

How do I manually get DStv signal?

How To Fix Signal Strength On DStv?

1. Check F-type connectors. Check for incorrectly connected F-type connectors on the LNB and at the back of the decoder.
2. Correct the LNB alignment.
3. Adjust satellite dish alignment.
4. Replace a faulty LNB.
5. Move your satellite dish.
6. Cut down or prune trees that may obstruct the signal.

How do I fix my satellite dish LNB?

How do I reset my DStv decoder?

How to reset your DStv decoder

1. Press the blue “DStv button” on your remote control.
2. Then use the right arrow on the remote control to go to “Settings“.
3. Use the down arrow to go to “System Settings“.
4. Now use the right arrow to go to the next menu and select “Reset Decoder Settings“