How do elevators decide which floor to go to?
Table of Contents
How do elevators decide which floor to go to?
Instead of simply pressing up or down, people waiting for an elevator can enter a request for a specific floor. Based on the location and course of all the cars, the computer tells the passengers which car will get them to their destinations the fastest. Most systems also have a load sensor in the car floor.
If you have a newer model elevator with ‘static sensitive’ buttons (these are the ones that light up when you touch them) and press the wrong button by mistake, press all the buttons. The elevator assumes you are being an elevator hooligan and resets the panel.
How do you stop a lift between floors?
Start by pressing the “door open” button and see if that works, then press the “door close” button. As both of these can get jammed and stop an elevator. If neither of the buttons works, try pressing the button for a floor below you. If these three buttons aren’t working, however, don’t mash them.
Where do elevators rest?
The elevators may stay at the last floor used, or they may pre-position to where they are most likely to be needed. In a multi-elevator system, there would always be some waiting at the ground floor. Others may be stationed half-way, or staggered through the building to reduce the waiting time.
Two Call Buttons are used outside the Elevator to determine which Direction you’ll be going and to avoid the elevator reach maximum capacity by putting request calls on HOLD by preventing to halt on floors where the person wants to travel an opposite direction.
What are elevator buttons?
Call Buttons are used to request an elevator. They are mounted 42″ above the finished floor and consist of an up button and a down button that illuminate to indicate the request has been received and an elevator is on the way. Hall Lanterns are used to indicate the arriving elevator and the direction it will travel.
How do you make a lift go straight to the floor?
Here’s what you do to go straight to your floor without stopping:
- Hold the close door until the doors close, but keep holding the button.
- Select your floor and do not let go of the number and close door button until the elevator moves.
- This will allow you to go directly to your floor without stopping.