Questions

What is the meaning of cascade control?

What is the meaning of cascade control?

Cascade control involves the use of two controllers with the output of the first controller providing the set point for the second controller, the feedback loop for one controller nestling inside the other (Figure 13.19). Such a system can give a improved response to disturbances.

What is cascade loop control system?

Cascade control is a control algorithm in which the output of one control loop provides the target for another loop, as shown in the diagram below. The ultimate goal of the cascaded loops is to control the end process. A standard PID control loop can be applied to this system, as shown in the figure.

Which of the following is a difference between feed forward and cascade control?

Feedforward is thus more specific than cascade control: it is designed to head off a particular disturbance. However, it cannot measure how well it did, nor can it respond to other disturbances, such as xd1, that might affect the controlled variable.

READ ALSO:   What are the economic consequences of the partition of India?

When tuning a cascade control system which of the following actions should be done first?

When tuning such controller, the inner most loop should be tuned first. The loop that manipulates the set point of the inner-most loop should be tuned next and so for. The figure below shows an example of using two secondary loops, independent of each other, in a fuel combustion plant.

What are the thumb rules for designing cascade control loops?

Tune the lowest loop first, then the next lowest loop, and ending up tuning the upper most loop last. For example, tune the valve positioners first, then the flow loop, then the jacket temperature loop, and finally the reactor temperature loop. Tune lower loops to be as fast as possible.

What is good control strategies Mcq?

Explanation: A good control system is a system with high speed of response and steady state error must be less and bandwidth should be large and noise must be very low and must be sensitive to parametric variations.