What is a recursive IPv6 static route?

In a next-hop/recursive static route, the IPv6 address of the neighboring router is specified. The output interface is derived from the next hop. Before any packet is forwarded by router, the routing table process must determine the exit interface to use to in order to forward the packet.

What is the difference between a directly connected static route and a recursive?

A directly attached static route relies on its exit interface in order for packets to be sent to its destination, while a recursive static route uses the IP address of the next hop router.

What is the purpose of a static route?

Static routing may have the following uses: Static routing can be used to define an exit point from a router when no other routes are available or necessary. This is called a default route. Static routing can be used for small networks that require only one or two routes.

What is the difference between a connected route and a static route?

Routers always add connected routes when interfaces have IP addresses configured and the interfaces are up and working. Static routing consists of individual ip route global configuration commands that define a route to a router.

How do I enable IPv6 routing on my router?

Enable IPv6 routing on a Cisco router using the ipv6 unicast-routing global configuration command. This command globally enables IPv6 and must be the first command executed on the router. Configure the IPv6 global unicast address on an interface using the ipv6 address address/prefix-length [eui-64] command.

What is recursive routing Cisco?

recursive routing occurs when a route either static route or dynamically learned has a next-hop that is not directly connected to the local router.

What are types of IPv6 static routes?

How to configure IPv6 Static Route

• Static floating route – outgoing interface.
• Static floating route – global unicast next hop.
• Static floating route – link-local next hop.

Is static or dynamic routing better?

Static routing provides higher security. Dynamic routing is less secure. Static routing is a manual process. Dynamic routing is an automatic process.

What is static routing in CCNA?

Static routes are manually added to a routing table through direct configuration. Using a static route, a router can learn about a route to a remote network that is not directly attached to one of its interfaces. The router with the next-hop IP address must be on a directly connected network.

Why would a summarized static route be configured on a router?

Why would a summarized static route be configured on a router? A summary route represents multiple networks. A summarized static route does not necessarily provide a better route than a routing protocol does. A default static route would provide a default gateway for a router that is connected to an ISP.