What is lockout in maintenance?

According to OSHA: “Lockout/Tagout is a complete program used to control hazardous energy during the servicing or maintenance of equipment, when the start up of the equipment or the release of stored energy could cause injury to employees.”

What devices can be used for lockout tagout?

Here are some of the types of devices available to help meet OSHA lockout/tagout standards:

• Padlocks.
• Safety tags.
• Devices.
• Lockout hasps.
• Group lockout boxes.

What is a machine lock out system?

Lockout means bringing every power source in a machine or system down to a zero energy state. Some equipment can simply be switched off and locked out of service, but in many cases, the system involves several energy sources. For example, a press may be hydraulically powered, but electronically controlled.

What is a lockout used for?

The purpose of a “Lockout/Tagout” procedure is to protect employees from machines and equipment capable of causing injury due to unexpected energization, release of stored energy or the start-up of equipment while an employee is performing maintenance or servicing equipment.

When should lockout be performed?

If someone has to enter the machine, the power should always be locked out to keep the maintenance personnel safe. If a machine is performing abnormally it may be necessary to get up close and inspect it for problems.

What happens if a machine is not equipped to accommodate a lockout device?

It is the policy of the FAA that before any employee performs any servicing, modification, alteration, or maintenance on a machine or equipment where the unexpected energizing, startup, or release of stored energy could occur and cause injury, the machine or equipment shall be isolated and rendered inoperative through …

What is a Loto device?

Answer — LOTO (Lock Out Tag Out) is the physical restraint of all hazardous energy sources that supply power to a piece of equipment, machinery or system. Most equipment and machinery has an Energy Isolation Device. These devices are usually put into the off position to shut down the hazardous energy source.

When can tagout be used in place of lockout?

Tagout devices may be used in lieu of lockout devices only if the tagout program provides employee protection equivalent to that provided through a lockout program. capable of being locked out. tagout program if machines or equipment are not capable of being locked out.

How do you use lockout tagout?

The eight basic steps to a LOTO procedure are as follows:

1. Prepare for the shutdown.
2. Notify affected employees.
3. Shut down the equipment.
4. Isolate energy sources.
5. Apply LOTO devices to energy sources.
6. Release/control all stored energy.
7. Verify the lockout.
8. Maintain the lockout.

What is an example of a lockout?

Lockouts are usually implemented by simply refusing to admit employees onto company premises, and may include changing locks or hiring security guards for the premises. Other implementations include a fine for showing up, or a simple refusal of clocking in on the time clock.

How are lockout and tagout devices applied?

Lockout or tagout devices shall be affixed to each energy isolating device by authorized employees. Lockout devices, where used, shall be affixed in a manner to that will hold the energy isolating devices in a “safe” or “off” position.

What are the 6 steps of lock out/tag out?

Let’s look at each of these steps of LOTO safety more closely in the sections below.

1. Lockout/Tagout Step 1: Preparation.
2. Lockout/Tagout Step 2: Shut Down.
3. Lockout/Tagout Step 3: Isolation.
4. Lockout/Tagout Step 4: Lockout/Tagout.
5. Lockout/Tagout Step 5: Stored Energy Check.
6. Lockout/Tagout Step 6: Isolation Verification.