What is non coincident?

Definition of noncoincidence : the fact or state of not coinciding : lack of coincidence Net metering will simply shift the burden created by noncoincidence of generation and load from the end user to the utility.—

What is coincident peak demand?

Coincident peak is your facility’s demand during the time when electricity demand systemwide is the highest.

What does coincident demand mean?

3.2.1 Coincident demand. The sum of the demands for the same time period. Sometimes also called the simultaneous demand or the diversified demand.

What does peak demand mean in electricity?

Peak demand is the time when consumer demand for electricity is at its highest; this can be by day, season or year. Peak periods tend to be in the morning during winter months (when lots of heating is occurring) and in the afternoon during summer months (lots of cooling).

What is a non coincident load?

Noncoincident loads are two or more loads that are unlikely to be in use simultaneously, so only the larger of the two loads must be used for the calculation. Careful use of this optional calculation can save customers money and still provide a very safe and effective job.

What is coincidence factor in electrical?

the ratio, expressed as a numerical value or as a percentage, of the simultaneous maximum demand of a group of electrical appliances or consumers within a specified period, to the sum of their individual maximum demands within the same period.

How do you find peak demand?

Utility companies typically measure power as the average demand over 15 minutes. This is done by adding up the energy consumed and then dividing by the interval of time, giving units of power, kW. The highest average 15 minute period of demand over a month is known as peak demand.

How do you calculate peak demand?

How is coincidence factor calculated?

The coincidence factor =Max. demand of a system / sum of the individual maximum demands

1. The coincidence factor =Max. demand of a system / sum of the individual maximum demands.
2. The coincidence factor is the reciprocal of the diversity factor.

Why is peak demand bad?

Peak demand may exceed the maximum supply levels that the electrical power industry can generate, resulting in power outages and load shedding. This often occurs during heat waves when use of air conditioners and powered fans raises the rate of energy consumption significantly.

What is non peak demand marketing?

(ˌnɒnˈpiːk) obsolete. a period of low demand; off-peak.

What is a non-coincident load give one example?

So a heater and an air conditioner both controlled by the same thermostat would be non-coincidental, because the thermostat will only operate one mode at once. But a water heater and an HVAC system which have completely unrelated control systems, would not count.