What should you not do when hanging drywall?

Hanging Drywall Vertically: Avoid Tapered Edges on Outside Corners. If you hang a sheet of drywall with the tapered edge along an outside corner, it will be hard to install the corner bead accurately (left). The corner of the bead will lie too low, making it difficult to cover with joint compound.

Should drywall go horizontal or vertical?

On commercial jobs, fire codes often require seams to fall on the entire length of the framing, so the drywall must be hung vertically. However, on residential jobs, the drywall on the walls is typically hung horizontally. For walls 9 feet high or shorter, hanging the drywall horizontally has a number of benefits.

Can you put up drywall horizontally?

For walls nine feet high or shorter, hanging the drywall horizontally has a number of benefits. Fewer seams – Horizontal hanging reduces the lineal footage of seams by about 25\%. Hides uneven studs – Hanging horizontally also allows the drywall to flow over the framing so that bowed studs create less of a problem.

Should drywall touch the floor?

Always leave a 1/2-inch gap at the floor. This allows for floor and wall expansion without cracking the drywall. It also helps prevents moisture wicking if the floor floods. Wear work gloves, safety goggles and a dust mask when hanging drywall.

Should drywall be staggered?

It’s not necessary to stagger seams on ceiling drywall. However, because these joints are relatively difficult to finish—and tend to be noticeable in the finished product—it’s a good idea to stagger the drywall panels to make the joints less visible.

How far apart should the screws be when hanging drywall?

Start screwing the drywall to the wall studs (Image 4), sinking each screw below the surface of the drywall, spacing the screws 12 to 16 inches apart.

Do you drywall ceiling or walls first?

Hang drywall on the ceiling first, then the walls. Check the ceiling for bowed joists using a 4-ft.

Does drywall have to end on stud?

All edges of all sheets of drywall must land on a solid surface such as a stud. A hanging drywall edge may work in the short-term, but in the long-term it can result in cracks and other serious wall issues. Less often, drywall does not vertically reach a solid attachment point.

How much gap should be between sheets of drywall?

However, during installation, be diligent about keeping that 1/8-inch space between sheets by using a guide. The blade of a drywall square is about 1/8-inch thick and does the trick. Thin strips of wood can also be used as spacing guides.

What should I put between drywall and concrete?

The solution is covering concrete with a vapor barrier, which acts like a resistant cell membrane instead. With a shield in place, the drywall is safe. Typically, a stud wall is then installed against the concrete, but furring strips are quick, easy and take up less space.

Is it code to stagger drywall?