How do you plug in guitar pedals?

How to Connect your Pedals to your Guitar and Amp

1. Make sure your amp is turned off.
2. Connect your guitar cable to your guitar.
3. Then plug the other end into the “input” side of your pedal.
4. Plug another guitar cable into the “output” side of your pedal.
5. Then plug the other end into the “input” on your amp.

What goes first distortion or reverb?

so they can process and modify the tone built by the pedals before it. If you put it before the distortion, then you are distorting the sound of the flanger. Delaying reverb can sound muddy, so it’s usually better to have the reverb after the delay. And last, but certainly not least, is the Loop Station.

How do you organize guitar pedals?

Dynamics (compressors), filters (wah), pitch shifters, and Volume pedals typically go at the beginning of the signal chain. Gain based effects such as and overdrive/distortion pedals come next. Modulation effects such as chorus, flangers, phasers typically come next in the chain.

Does distortion go before wah?

There are people that put the Wah-Wah before the distortion, but it should always go before the effects that involve modulation and time. Distortions, overdrives and fuzz are used to give shape and grit to the basic and unadulterated signal.

How do you hook up a chorus pedal?

Where to Place a Chorus Pedal In Your Effect Chain. Chorus is a modulation effect, and as such, it should be placed fairly late in your pedal chain. It should come after a wah pedal, compression pedal, overdrive pedal, and distortion pedal, but before your delay pedal, tremolo pedal, or reverb pedal.

Do I need chorus pedal?

A chorus pedal is a great way to create thicker sounds from a single signal. By taking your source signal, doubling it and setting the second signal slightly out of tune and time with the first, a chorus pedal can create the sound of two instruments playing simultaneously.

How do I order gain pedals?

When stacking 2 pedals, remember that volume before dirt = more gain, where volume after dirt = more volume. Again, the 2nd pedal acts as a “gate” and dictates the overall volume. Cranking the output of the first pedal will push the input higher and clip the signal harder.