What ammo does a Marlin Model 60 shoot?

.22 LR
The Marlin Model 60, also known as the Marlin Glenfield Model 60, is a semi-automatic rifle that fires the .22 LR rimfire cartridge.

Should I clean my .22 rifle?

22 LR bullets are lead, even those copper-washed. All leave material in the barrel, which degrades accuracy over time. In my experience with my match guns, I have had to carefully use a chamber reamer to remove this buildup where the bullet enters the barrel’s throat. Thoroughly clean the rifle inside and out.

Why is 22lr so dirty?

Rimfire ammunition is somewhat unique in that it has four contributing factors to barrel fouling. The wax used to lubricate the bullets is the most obvious. 22 LR bullets are lead, even those copper-washed. All leave material in the barrel, which degrades accuracy over time.

What is the cleanest 22lr ammo?

Remington Golden Bullets, CCI MiniMags, and Winchester Super X agree the cleanest IMO.

What’s the fastest 22LR ammo?

Ammo Review: CCI COPPER-22, the Fastest . 22 LR Ever. CCI’s new COPPER-22 advertises that it sends a 21 grain lead-free projectile down range at 1,850 fps.

What do you do when your Marlin 60 won’t eject?

Marlin 60 Failure To Eject (Marlin 60 FTE): (1.) Clean action thoroughly and on reassembly put max one drop of oil on bolt surfaces only. They don’t operate oiled up. Or use a proven dry lube. (2.) Check position of ejector wire (3.) Strip bolt and clean and check condition of extractors. Replace if needed. (1.)

Why does my 22 rifle keeps jamming?

Ammunition lasts a long time when your.22 will only fire one round at a time. The short answer to “My 22 Rifle Keeps Jamming” is you need to find what ammunition works best in your.22. Now don’t think you need to run out and buy the most expensive.22 ammunition on the market.

What should I do if my Marlin 60 or Marlin 795 fails to cycle?

If you have an intermittent failure to cycle with your semi automatic Marlin 60 or Marlin 795, determine if it is failure to load (FTL), failure to fire (FTF), or failure to eject (FTE). ***If you have a bent recoil spring and can’t immediately replace it, straighten it best you can with needle nose pliers.

How do I clean the bolt on my Marlin action?

A piece of glass w/ a fine (500) grit piece of sandpaper oiled up while moving the bolt in a figure 8 motion, will get rid of any high marks left over from the factory. Cleaning the bolt w/ brake clean and a drop of CLP finishes off the job. We have had great success using this method to make the Marlin 60 and Marlin 795 action function better.***