How do you calculate the volume of water in a swimming pool?

Length x width x average depth x 7.5 = volume (in gallons) Length times width gives the surface area of the pool. Multiplying that by the average depth gives the volume in cubic meters. If you’d like to find the pool volume in gallons, multiply your results by 7.5, as there are 7.5 gallons for each cubic foot.

How much pressure is on a pool wall?

The water pressure stays exactly the same…it’s dependent on the depth, but not on the width of the container. So the water pressure at 3.5′ depth will be 1.52 psi whether it’s in a 55 gallon drum, a 2″ vertical pipe or against a swimming pool wall.

How much pressure is at the bottom of a pool?

The chart shows that 2.31 feet of water will create one PSI. So in CPO class, I ask the students: “How much pressure is at the bottom of a 10 foot pool?” The answer: you just divide 10 by 2.31 (feet per one PSI), which equals: 4.33 PSI (wow–my ears hurt already!).

What is the pressure of water?

Normal water pressure is generally between 40 and 60 PSI; most homeowners prefer something right in the middle around 50 PSI.

What is the pressure at the bottom of a swimming pool?

The pressure is independent of the area of the pool. Pressure is only dependent on the depth of the water. The force on the bottom of the pool is PA (pressure x area). Water weights approximately 1/2 pounds/ft. sorry I am too lazy to do the conversion.

How do you calculate the volume of a swimming pool?

The cubic volume can be calculated by including the depth of the pool with the surface area. For accurate calculations, the pool should be divided into various areas according to the depth. Length times width gives the surface area of the pool. Multiplying that by the depth gives the volume in cubic feet.

How do you measure the length of a swimming pool?

Measure the length, width, and average depth of the pool, rounding each measurement off to the nearest foot or percentage of one foot. One inch equals 0.0833 feet. Therefore, multiply the number of inches in your measurements by 0.0833 to get the appropriate percentage of one foot. Example: 25 ft, 9 in. = 25 ft + (9 in. x 0.0833)

How much force does it take to build a swimming pool wall?

So taking the halfway average, the total force is 29.9 x 1150 = 34385 kgf total, each wall. However if you are calculating what sort of props, or reinforcing is needed for the pool walls, keep in mind that this force is not evenly distributed from top to bottom.