How thick can you pour concrete without rebar?

If you don’t put rebars in a 4-inch [10 CM] slab, then it won’t be reinforced concrete – and won’t perform. As a general rule, any section of concrete must have at least 0.25\% of its area in rebars to be considered reinforced concrete and do the intended job.

How much concrete do I need for top of rebar?

To be most effective for this purpose, the reinforcement needs to be near the top of the slab. For corrosion protection, however, most specifications require a minimum depth of concrete cover that usually ranges from 1 inch to 2 inches.

How thick and wide should a footing be?

Footing width can vary according to the structure, site, and conditions. Under code, generally, one-story buildings with footings on undisturbed soil with LBVs between 1,500 and 4,000 should have a minimum width of 12 inches. Two-story buildings require a minimum of 15-inch wide footings for 1,500 LBV soil.

How thick does a concrete pad need to be?

Standard concrete floor slab thickness in residential construction is 4 inches. Five to six inches is recommended if the concrete will receive occasional heavy loads, such as motor homes or garbage trucks. To prepare the base, cut the ground level to the proper depth to allow for the slab thickness.

Is rust on rebar a problem?

Reinforcing bar and mesh often arrives on site with some rust on it. Generally speaking, rust on your reinforcing steel isn’t a problem where it’s formed by fresh water and research has demonstrated that a light coating of rust may actually help to increase the bond with concrete.

What size concrete pad do I need for my carport?

For example: if the carport is 18 feet wide by 21 feet long then you may choose to make your concrete pad 18 feet and 4 inches wide by 21 feet long. Please call us if you have any other questions our staff is ready and will be happy to help you.

What size PAD do I need for my garage?

Pad Sizes are listed with the width first and the Length Second. Listed below are the suggested sizes of the Metal Garage Concrete Pad except for the State of California (please contact us for California for more information): 12′ wide x 21′ roof length and 20′ actual foot print: pad size 12′ wide x 20′ long

What size roof PAD do I need for a 22×20?

18′ wide x 21′ roof length and 20′ actual foot print suggested pad size 18×20 20′ wide x 21′ roof length and 20′ actual foot print suggested pad size 20×20 22′ wide x 21′ roof length and 20′ actual foot print suggested pad size 22×20

How much subgrade do I need for a 4 inch concrete pad?

If you’ve dug down 6 inches and want the pad to finish 2 inches above the ground, you’ll need to add 4 inches of subgrade material. This will allow for a 4-inch pad, a typical and adequate thickness for most home-based uses.

https://www.youtube.com/watch?v=DIDgpFoB944