When same voltage is applied to both the inputs of an op amp the output voltage is infinite?

An operational amplifier only responds to the difference between the voltages on its two input terminals, known commonly as the “Differential Input Voltage” and not to their common potential. Then if the same voltage potential is applied to both terminals the resultant output will be zero.

Which is the correct equation for the relationship between the output and input voltages of an ideal op amp?

If we take an op-amp and we short together the input terminals so that V+−V-=0 , the output will be Vout=Voffset .

What is the output voltage of an op amp?

Output voltage is limited to a minimum and maximum value close to the power supply voltages. The output of older op amps can reach to within one or two volts of the supply rails. The output of so-called rail-to-rail op amps can reach to within millivolts of the supply rails when providing low output currents.

What is the relationship between input and output of a differentiator?

In electronics, a differentiator is a circuit that is designed such that the output of the circuit is approximately directly proportional to the rate of change (the time derivative) of the input.

Which factor determines the output voltage of an op-amp?

These saturation voltages (positive and negative saturations ) are specified by an output voltage swing rating of the op – amp for the given values of supply voltage. Therefore the factor to determine the output voltage of op – amp is positive and negative saturation.

Which factor determines the output voltage of an op amp?

What will be the output if supply voltage is +/- 15v?

I got this equation for a summer circuit output voltage fed into an inverting opAmp. Both opAmps have supply voltage of ±15 V. Vout = -6*V1-30*V2-60*V3. I got Vout = -390 mV.

What is differential input voltage of op amp?

zero volts
In normal operation, an op amp has the feedback loop connected; therefore the differential input voltage is held at zero volts (neglecting the offset voltage). However under certain conditions, such as power-up, the op amp may be subjected to a differential input voltage which is not zero.

What is the output voltage of the differentiator?

The output of a differentiator is proportional to the rate of change of its input signal, If the input voltage is constant (DC) dv/dt = 0, and the output voltage is zero, Posted on April 23rd 2021 | 4:58 pm.

What will be the output voltage waveform for the differentiator circuit when input is a square voltage?

If the input to the differentiator is changed to a square wave, the output will be a waveform consisting of positive and negative spikes, corresponding to the charging and discharging of the capacitor, as shown in the figure below.