How do I fix error code 0x0000001?
Table of Contents
How do I fix error code 0x0000001?
Fix Error Code 0xc0000001 on Windows 10
- Perform Startup Repair.
- Uninstall Problematic Software in Safe Mode.
- Use Command Prompt.
- Run System Restore.
- Reset your PC.
- Reinstall Windows 10.
How do I fix my computer couldn’t start properly?
5 Ways to Solve – Your PC Did Not Start Correctly
- Method 1: Uninstall New Software or Drivers.
- Method 2: Run Startup Repair.
- Method 3: Run System File Checker.
- Method 4: Rebuild BCD.
- Method 5: Windows Reinstall.
What is the first step of troubleshooting when a PC doesn’t boot up?
How to troubleshoot your Windows PC when it won’t turn on
- Try a different power source.
- Try a different power cable.
- Let the battery charge.
- Decrypt the beep codes.
- Check your display.
- Check your BIOS or UEFI settings.
- Try Safe Mode.
- Disconnect everything non-essential.
What is 0xc0000225?
First off, error code: 0xc0000225 means Windows cannot find the System Files used for booting, aka, BCD (Boot Configuration Data). In other words, if your system files are corrupted, the disk file system has a bad configuration, or if you have faulty hardware, the 0xc0000225 error would occur.
Can I reset my PC from the BIOS?
Use the arrow keys to navigate through the BIOS menu to find the option to reset the computer to its default, fall-back or factory settings. On an HP computer, select the “File” menu, and then select “Apply Defaults and Exit”.
How do I force my computer to factory reset?
To reset your PC
- Swipe in from the right edge of the screen, tap Settings, and then tap Change PC settings.
- Tap or click Update and recovery, and then tap or click Recovery.
- Under Remove everything and reinstall Windows, tap or click Get started.
- Follow the instructions on the screen.
How do I fix error 0xc0000225?
Follow the below steps to hopefully fix the issue, no matter the cause.
- Step 0: Create a Windows 10 Install Disk.
- Step 1: Run Through Windows Automatic Repair.
- Step 2: Run Manual SFC and Check Disk Scans.
- Step 3: Rebuild the BCD.
- Step 4: Set Your Active Partition.
- Step 5: Check for Faulty Hardware.