How do I run diagnostics on Maytag Centennial?

Starts here5:38How to Run Diagnostics and Read Error Codes on a Maytag WasherYouTubeStart of suggested clipEnd of suggested clip60 second suggested clipAnd then when it engages the lights flash. And if we do one more tick to the right. The done lightMoreAnd then when it engages the lights flash. And if we do one more tick to the right. The done light lights. Now if I were to push start now it would allow me to read any previous error codes.

What causes a Maytag Centennial washer not to spin?

One common cause why a Maytag top load washer won’t spin is due to an uneven load or jammed clothing. Larger items or loads tend to settle on one side of the washer drum during a cycle. Try to redistribute the load or remove a few articles of clothing and run the spin cycle on your washer again.

How do I reset my Maytag Centennial washing machine?

1. Unplug the washer for 1 minute from the electrical outlet.
2. Plug the washer back in and lift and lower the lid 6 times within a 12 second period. You have 30 seconds to start lifting and lowering the lid.
3. The motor has now been reset and is ready for you to start a cycle.

How do you run diagnostics on a Maytag washer?

Choose any one button on the washer’s console except Power, Start, or Stop. Press/Hold 3 Seconds – Release 3 Seconds – Press/Hold 3 Seconds – Release 3 Seconds – Press/Hold 3 Seconds. 4. If there are any saved fault codes they will be displayed.

How do you calibrate a Maytag Centennial washing machine?

Starts here2:03Whirlpool Maytag Top Load Washer Calibration Diagnostics – YouTubeYouTube

How do you reset the sensor on a Maytag washer?

If an error message causes your Maytag washer to not run properly, reset the washer to clear the error message….How to Reset a Maytag Washer

1. Press the “Power/Cancel” button.
2. Push the appropriate button to choose a new cycle.
3. Press “Start/Pause.” You have now reset your Maytag washer.

Is there a reset button on Maytag washing machines?

Press and hold the Start/Pause button for 3 seconds. All indicator lights should be off at this point. Reset the Washer: To reset (clear) the washer, rotate the Cycle Selector Knob counter-clockwise (left) to clear any sequence.

How do I know if my washing machine actuator is bad?

When the actuator fails there is usually and awful lot of grinding noise, and the tub and agitator operate at a slow speed, if at all. In most models, you will have an F7 -E1 or E5 error code in the display.