What is the difference between Elliot and Reverse Elliot stub axles?

Types of Stub Axle Elliot: This type uses a kingpin, a yoke, and a cotter to connect to the front axle. Reverse Elliot: This type has the opposite arrangement of a standard Elliot stub axle. Lamoine: This stub axle type has an L-shaped spindle instead of a yoke-type hinge.

What is stub axle for?

A stub axle or stud axle is either one of two front axles in a rear wheel drive vehicle, or one of the two rear axles in a front wheel drive vehicle. In a rear wheel drive vehicle this axle is capable of angular movement about the kingpin for steering the vehicle.

What is Reverse Elliot stub axle?

The reverse Elliot type stub axle forms the fork end to receive the front axle beam. The front axle end forms eye, and the thrust washer place at the bottom of the front axle beam that is at the contact face with the stub axle. The cotter pin in the joint that locks the movement of the kingpin in the front axle.

What are the types of stub axle?

Types of Stub Axle Following are the four types of the stub axle: Elliot. Reverse Elliot. Lamoine.

Why are stub axles fitted in front axles?

These axles do not rotate with the driver when compared to live axles. The Dead front axle has sufficient rigidity and strength to transmit the weight of the vehicle form the springs to the front wheels. The ends of the axle beam shape suitably to assemble the stub axle.

Which attaches the wheel and stub axle?

#3. Stub Axle. Stub axles are attached to the front wheels of the vehicle and are connected to the front axle by the kingpin.

What are stub axles made from?

Stub Axles, also referred to as Short Axles, differ from front and rear alternatives. Forged of 3\% nickel steel and alloy steels made up of chromium and molybdenum, they carry one of the front steered wheels and provide limited, angular movement about a kingpin.

How the stub axles are connected to the front axles?

This type of stub axle attaches to the front axle by placing it in the yoke end with a kingpin & a cotter to connect the two together. The swivel pins are usually fixed in the stub axle forging, which is intended to forcibly close the axle beam. The axle beam is formed as a gamble and receives a stub axle.

What are stub axles made of?

What is full floating axle?

A full floating axle consists of a wheel hub assemble that is separate from the axle shaft. A spindle bolted to the axle tube supports the wheel hub by means of a pair of wheel bearings. Full floating axles are rather heavy, but have very large weight carrying capacities.

Why are stub axles are fitted in front axles?

A stub axle is a sub-assembly of a front axle beam upon which the road wheel mount. Stub axle is connected to the front axle using kingpin. These stub axles turn about the kingpin, which is light drive fit in the axle beam eye, located and locked by the taper cotter pin.

How is a stub axle made?

For maximum strength to weight ratio, a stub axle needs to be forged from steel. Forging will allow the stretched fibres in the steel to follow the lines that will carry load when in operation. You could start with a short round bar. Upset or spread one end to make the flange, while thinning and lengthening the shaft.