How do you measure a cam lock on furniture?

The length of a cam lock is measured from the center of the hole to the end of cam, start behind the cam head and measure along with the cylinder to the inside face of the cam.

What is a cam lock connector?

A camlock connector, is an electrical single pole connector often used in temporary electrical power distribution. Cam-Lock connectors are also used to build disconnects to lighting dimmer racks and distribution panels and to connect large generators. Usually found in professional and industrial settings.

How are cam Connectors measured?

With most cam couplings, measure the Outside Diameter (OD) of the adapter head or the Inside Diameter (ID) of the coupler. This will identify the fitting size, as depicted in the images bellow.

How do I know what size cam lock I need?

The correct way to measure a lock cylinder for length is by the threads. The correct way to measure for width is by the two flat spots. Therefore, based on the photo you attached, you will need a 7/8″ long lock cylinder like the Camco Cam Lock part # CAM44323 if your two flat spots measure to be 5/8″.

What is a cam lock screw?

Cam screws are generally supplied as components for flat-pack furniture. Cam or locking screws are 2-part screws where the cam is fitted in one piece and the screw in a piece to be joined to this piece. By slotting the two pieces together and tightening the screw you have a reasonably secure join.

What is a cam screw?

How does a cam lock work?

A cam lock slides into a hole in the surface of the second piece and locks onto the top of the post, pulling the joint together as the cam locks into place. I have only seen them used in pre-cut furniture that’s designed for home assembly, but I knew I could get them at my local home center.

How to install cam bolts and dowels?

Screw in Cam Bolts as shown below Push in the Dowel with fingers as shown below and then lightly tap with hammer to make sure it is held firmly Place both pieces of panel as shown together Make sure grooves are fitted properly as shown below

Can you use a drill press to drill a hole?

Because these bits are minimally guided by a central drill point, use in a drill press is recommended (to prevent sideways drift). Careful use freehand can also work. Go slowly at the start, until the full circumference is inscribed, then higher pressure can be used.

What size drill bit do I need for a small hole?

A frequently used bit is a Forstner style bit, which drills (nearly) flat bottomed holes. . For the smaller sizes (< 1/2 inch, <13mm) , a brad point bit is also usable and also (nearly) flat bottomed.