Advice

How do you convert 6V DC to 5V DC?

by Author

How do you convert 6V DC to 5V DC?

You need two basic blocks, one to convert the AC voltage to DC and another to step down and regulate the resulting DC voltage. In the output of this you’ll get about 6v x 1.414 ~ 8.44v – 1.4v = 7v (the 1.4v drop is caused by the bridge diodes), then you only need to connect a regulator to step this down to 5v.

Can I use 6V for 5V?

If you’re mildly comfortable with electronic circuits, you could convert the 6V adapter to 5V. This can be done by hooking up the output of the adapter to a simple 5V linear regulator (the 7805) — the dropout would probably be low enough at 200mA to supply 5V.

READ ALSO:   Why does Doctor Manhattan not wear clothes?

Can I use a 6V adapter to power a 5V device?

You could convert the 6V adapter to 5V if you’re comfortable with electronic circuits. This can be accomplished by hooking up the output of the adapter to a simple 5V linear regulator, which will probably have a dropout of 200mA.

Can I use a 7.5 V adapter for a 5V device?

It could work fine in the long run, it could destroy the switch instantly, or it could work for a long while and then enter a thermal run-away without warning while you’re not looking/present. Go to Radio Shack, buy proper adapter, and don’t worry about house fires.

How do I get 5V supply?

Simple 5V Breadboard Power Supply

  1. Step 1: List of Components. A 9V wall adapter, with a jack barrel output.
  2. Step 2: The Jack Barrel.
  3. Step 3: Wiring the Regulator.
  4. Step 4: Testing the Voltages.
  5. Step 5: Add a LED to Show the State of the Power Supply.
  6. Step 6: Protect Your Adapter From Short Circuits.
READ ALSO:   Why did tywin not suspect Arya?

How do I get 5V DC supply?

Step by step method to design 5V DC power supply

  1. Step 1: The selection of regulator IC.
  2. Step 2: The selection of transformer.
  3. Step 3: The selection of diodes for the bridge.
  4. Step 4: The Selection of smoothing capacitor and calculations.
  5. Step 5: Making the power supply safe.

How do you convert 6v to 3v?

from a 50amp supply at 5 volts you’d need a dropping resistor to drop 6–3 =3 volts at 50amps. You’d need a resistor of (R=V/I) – 3/50=0.06 ohms, not an easy value to get or make. And the power (Watts) is V x I =3 x 50 = 150 watts. This is totally wasted power.