Advice

How do you handle and store a microscope?

How do you handle and store a microscope?

Hold the microscope with one hand around the arm of the device, and the other hand under the base. This is the most secure way to hold and walk with the microscope. Avoid touching the lenses of the microscope. The oil and dirt on your fingers can scratch the glass.

How do you keep a microscope in good condition?

Store safely. Keep the microscope in a draft-free, dry place, where it won’t get bumped, pushed, wet and where things will not fall on it. Make sure the microscope is level to the table/bench.

What is the correct way to store your microscope when you are done using it click all that apply quizlet?

THE MICROSCOPE SHOULD BE STORED WITH THE (OIL IMMERSION) LENS IN POSITION OVER THE STAGE.

READ ALSO:   Who invented science fiction?

Which precaution should be taken while handling the microscope?

Answer:

  1. always keep the microscope in vertical position .
  2. always pick the microscope by the arm.
  3. first examine the material slide under low pressure and then under high power.
  4. object should be obeserved with both eyes open.
  5. clean the lenses of the microscope with lens cleaning solution and cleaning paper.

Do and don’ts of microscope?

Don’t touch the lenses of the microscope with your fingers. Keep slides and cover slips clean. Use anything OTHER than lens paper to clean them. NEVER aim the Lumarod or microscope at the sun or look directly into the sun.

Why do you need to care and maintain your microscope?

Microscope lenses are difficult to clean and proper care is very important. Failure to do so can result in the oil making its way into into mechanisms that will cause damage to the microscope and sometimes this damage can be irreversible.

When you get your microscope if it was stored correctly it should?

The microscope should be stored with the oil immersion lens in position over the stage. 3. When beginning to focus, the lowest power lens should be used.

How would you bring a microscope back to its storage area after using it?

Your hands should also be dry • when using a microscope. Remember to unplug the microscope from the electrical outlet by • grasping and pulling the plug, not by pulling on the power cord. Coil the power cord neatly around the arm of the microscope when returning the microscope to its storage area.

READ ALSO:   What happens if I crash a courtesy car?

Which objective lens should be in place when storing the microscope?

4X objective
Always place the 4X objective over the stage and be sure the stage is at its lowest position before putting the microscope away.

Why should you keep water away from the microscope?

Keep the stage dry at all times. Fluids can damage metal parts and also make it difficult to move a slide around on the stage. 3. The light source is housed in the base of the microscope.

What is microscope etiquette?

Always grip the microscope by the arm and put your hand beneath its base. Hold the scope upright at all times. Do not bump it against anything. 4. Before you use the scope, check it to be sure it was put away properly by previous users.

How often should microscope be serviced?

Compound microscopes should generally be serviced after about 200 hours of use. For most schools, this would be about every three years, possibly more frequent if the microscope is used multiple times each day.

How do you store a microscope without damaging it?

If the cover has zippers or buttons to seal it shut, make sure these are buttoned or zipped correctly. Store the microscope on a flat table or surface where it will not be jostled or knocked over. Ensure that the storage area does not expose the microscope to prolonged periods of direct sunlight.

READ ALSO:   How long can JBL Flip 5 last?

How do you clean the lenses of a microscope?

Lens cleaning papers and solution can be found at camera supply stores. Turn the lenses so that they are facing the stage, or the tray where slides are placed to view items through the lenses. Cover the microscope with a plastic microscope cover. If the cover has zippers or buttons to seal it shut, make sure these are buttoned or zipped correctly.

How do you secure a dust cover on a microscope?

Zip up the zipper or snap the clasps to secure the dust cover. This is an important step in keeping your microscope safe and dust free. If your cover does not have a zipper or snaps, make sure it is covered completely by the dust cover. You can tuck the cover around the base to secure it in place.

How to extend the life of Your Microscope?

To extend the life of your microscope, store it wisely. Because dust can scratch the lens of a microscope and interfere with the magnification process, the main objective of storing a microscope is to keep it protected from dust and other elements.